Forum - MCS Electronics

 

FAQFAQ SearchSearch RegisterRegister Log inLog in

Search found 247 matches
www.mcselec.com Forum Index
Author Message
  Topic: Problem with UART and Luciano Loopback software
pinkfloyd11

Replies: 0
Views: 234

PostForum: BASCOM-AVR Archive   Posted: Tue Jul 31, 2007 4:02 pm   Subject: Problem with UART and Luciano Loopback software
Dear Friends,

I have a device already programmed and working that use ATMEGA16.

I must replicate a firmware of this device.

This device have 2 connectors: programming connector and communi ...
  Topic: Serial comunication
pinkfloyd11

Replies: 0
Views: 429

PostForum: BASCOM-AVR Archive   Posted: Tue Jul 31, 2007 1:19 pm   Subject: Serial comunication
Dear Friends,

I have a device already programmed and working that use ATMEGA16.

I must replicate a firmware of this device.

This device have 2 connectors: programming connector and communicat ...
  Topic: EEPROM Write and Read
pinkfloyd11

Replies: 1
Views: 395

PostForum: BASCOM-AVR Archive   Posted: Sun Jul 29, 2007 10:28 pm   Subject: EEPROM Write and Read
Dear Friends

(long but easy.. Smile )
With the follow code I can write and read in EEPROM without create the EEP File. Moreover since I know the exact address in EEPROM I can recover the data also wi ...
  Topic: ATMEGA16 and PortC
pinkfloyd11

Replies: 11
Views: 729

PostForum: BASCOM-AVR Archive   Posted: Fri Jul 27, 2007 6:00 pm   Subject: SAMPLE PROGRAM
Dear Giovanni

can you explane me better your last post?

Thanks

Giuseppe
  Topic: ATMEGA16 and PortC
pinkfloyd11

Replies: 11
Views: 729

PostForum: BASCOM-AVR Archive   Posted: Fri Jul 27, 2007 1:29 pm   Subject: Yes, I'm using STK500 but....
Dear Luciano

yes, I'm using STK500 but I'm programming an external device with ATMEGA16 and XTAL 13.56Mhz by ISP6PIN connect to the external board.

Thanks
  Topic: ATMEGA16 and PortC
pinkfloyd11

Replies: 11
Views: 729

PostForum: BASCOM-AVR Archive   Posted: Fri Jul 27, 2007 11:15 am   Subject: Can I set fuse bit by code
Dear Luciano

can I set fuse bit by code?

I have sucessfull remove the limitation of Jtag by AVR Studio4 Programmer.

Now if possible I would change this fuse bit directly by my program.

Mor ...
  Topic: ATMEGA16 and PortC
pinkfloyd11

Replies: 11
Views: 729

PostForum: BASCOM-AVR Archive   Posted: Thu Jul 26, 2007 4:51 pm   Subject: ATMEGA16 and PortC
Dear Friends

I cannot use Port C on ATMEGA16.
Reading on forum I have found that this port is fused to the JTAG as default when the chip is produced.

Now the question is:

How I can remove th ...
 
Page 17 of 17 Goto page Previous  1, 2, 3 ... 15, 16, 17
All times are GMT + 1 Hour
Jump to: