Search found 112 matches

So finally last chapter about my first robotic arm. You can see it there https://www.youtube.com/watch?v=FdPu8XA_B-Y.
Now I can say that:
- during this project, I came to the conclusion that atmega3 ...

So in the end working project. Interesting is that after changing my usb-uart converter I had no more problems with the Micro. Here you can see finished machine https://www.youtube.com/watch?v=GtmhI39 ...

I found the cause but don't know yet why. After reseting Micro (button push) I have to disconnect usb (one as a power) and second usb where is my uart-usb converter. Also close Bascom terminal. Then c ...

Hi,

MWS - absolutely righ Smile

I had to mix something during copy-paste
EDC - both versions work in simulation, but on real hardware somehow don't. I use avrdude with params
-p atmega32u4 -c avr1 ...

Hi,

this code is similar to code I use on Uno, except that interrupts are on different pins. On Uno this code works but on Micro it seems that timer0 interrupt is not executed or should I make it ...

Oh, I simply mixed coms up. My expectation was that after uploading I'd see in terminal emulator incomig data via Micro usb data. wrong way. I had simply to connect to RX/TX pins of Micro to usb conve ...

A little progres, (this link: https://forum.arduino.cc/t/avrdude-cant-find-com/626194/3) :
The Arduino IDE does a special process when uploading to the Leonardo that doesn't happen when you are uploa ...

Hi,

It touches barely to Bascom (exept that hex filke is done there) but need to port my project from Uno to Micro. As I've already found out from 'internet' that to upload hex file is to use avrd ...

What i've noticed that not always it works (my previous description light-sleep). Don't know why. Anyhow yesterday I've bought esp8266-12 and it has reset pin set out on pcb. Tested At command "AT+GSL ...

Thank you for the response. I considered something similar but having so much ahead to write on RaspPi and uC I gave this idea up (I consider myself more a programmer than electronic engineer). But ch ...

Hi,
perhaps a little off-topic, so then I'm sorry. Now I'm working on communicating PC-esp8266-uC. All commands between uC and esp8266 are as AT commands included in Bascom code on uC side. There is ...

Thank you for an answer and info. Surely i'll check that.

Regards,
Martin

Hi

I'd like to use new chips - new avr family like attiny85 and so on. What should I do in order to program them? I'm aware that I need to use Bascom ver. 2.0.8.3 and commercial add-on (btw. purch ...

Yes, resistance (working stability) for low temperatur is important. I'm still on a very initail stage of project thus there is not a problem to consider change of chip and there I've more points to t ...

There is a possibility of destructive load/pressure damage and that is why I decided to use tiny13 and the esp8266-01. This kind of sensor should give me a warning shortly before being damaged and th ...