Search found 9 matches

Thanks Mark & Evert,

"myAVR MK2 / AVR910" works well. I have 5 seconds after I push the reset button on the Adafruit to initiate a "download". The bootloader comes up as COM7 (in my case) the ...

Hi,

Has anyone tried programming the above mentioned board with Bascom over the virtual comm port? I have not used the Aduino system but I assume the bootloader should communicate with the Bascom ...

Thanks Mark.

As I suspected. I implemented a soft UART and that is working fine for me.

-G

Hello

Is there a way to invert the serial data using the hard UART in the ATmega (168 specifically)?

Thanks!

Hello Nard,

Nice write up on your web page. I will give it a try.

I just found it curious that the only thing I changed was the Bascom version.

Cheers,
Greg

Hi Evert,

I did that. No difference could be observed. I am not sure what the units are in but I went right up to 500. I can only assume that represents 500ms?

Cheers,
Greg

Hi,

Since upgrading from x.9.4 to x.9.8 I have had poor results trying to program an ATtiny261 using the dependable STK200 style ISP programmer.

If I "refresh" my fuse bits, about 50% of the tim ...

I am having major problems getting the Elektor AVR-ISP programmer to operate with Studio 4 and Bascom. I could get it to work with Studio 4 and it sort of worked with Bascom. In Bascom, I could view ...

Hi Steve,

I use the Freewave 900MHz (and 2.4GHz) spread spectrum radios which have an output power of 1 Watt. THey are used on open ocean and desert conditions and I routinely get 10km with a 6dB ...